Kreg router lift1/25/2024 ![]() There is a tremendous amount of experience and very deep thought behind anything that Derek posts. Remember: us idiots are very creative! Derek's Strategy ![]() Have to lift it out to do any adjustments or change bits a bit cumbersome, but it works and is almost idiot proof. I simply bolt my hefty Makita 3600B router to an insert plate and drop it into the table top. I'd love to hear from anyone who knows what real-world differences exist between the Jessem and Kreg lifts, or can confirm any benefit to the four post Carbatec approach.Īm looking to buy a router lift and am hoping somebody could give me some advice.īefore you make any decisions, Gordon, may I suggest that you consider three different strategies as advocated by Forum members Derek Cohen, Chris Parks and myself. I'm currently favouring the Kreg lift, because it will fit straight in my table whilst both the Carbatec and Jessem unit require other changes (I have read that Jessem supply specific corner brackets to fit their lift in a Kreg table, and Carbatec state "minor modifications required"). My plan is to buy a (Carbatec?) motor unit and release my TRA001 for hand held use. The Carbatec unit also has a greater range of insert rings available. It is a four post unit where all the posts rotate (driven by a chain) to raise the carriage, whilst the Jessem types have two "bearing" posts and a single threaded post to raise and lower the carriage. The outlier is the Carbatec unit, which is priced higher than the others (Kreg $499, Jessem $595, Carbatec $659). It may or may not be the same, it's hard to tell from pictures! The possible exception to this is the adjuster locking mechanism, which Jessem wax lyrical about in their blurb whilst Kreg simply list as a "lock". The differences between them appear to be relatively minor, things like the way the insert rings are held in position. My research so far suggests that the Kreg, Incra and Jessem lifts are all very similar, and indeed I have read that they are all made by Jessem. As a result I've started looking at upgrading the table with a "through the top" lift and dedicated router. ![]() I've also noticed that the Kreg phenolic top plate is no longer flat, which seems to be common with these units. This has done me good service for years, but recently I've been using it more and my poor old back resents bending down to adjust the bit height. I have a Kreg table (no lift, just a phenolic plate) with the older version of the Triton TRA001 router that doesn't have the "through the base" lift mechanism. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |